Altusen KN1000 Manuel d'utilisateur télécharger pdf (Page 63)

4. Administration

Adding Filters

To add an IP filter, do the following:

1. Click Add. A dialog box similar to the one below appears:

2. Key the address you want to filter in the From: field.

 To filter a single IP address, key the same address in the To: field.

 To filter a continuous range of addresses, key in the end number of the

range in the To: field.

3. After filling in the address, click OK.

4. Repeat these steps for any additional IP addresses you want to filter.

To add a MAC filter, do the following:

1. Click Add. A dialog box similar to the one below appears:

2. Specify the MAC address in the dialog box, then click OK.

3. Repeat these steps for any additional MAC addresses you want to filter.

IP Filter / MAC Filter Conflict

If there is a conflict between an IP filter and a MAC filter – for example, where

a computer’s IP address is allowed by the IP filter but it’s MAC address is

excluded by the MAC filter – then that computer’s access is blocked.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 193 194

Pas de commentaire

Altusen KN1000 Manuel d'utilisateur Page 63