Altusen KN1000 Manuel d'utilisateur télécharger pdf (Page 27)

Chapter 2

Hardware Setup

Mounting

Rack Mounting

For convenience and flexibility, the KN1000 can be mounted on a system rack.

To rack mount the unit do the following:

1. Remove the two original screws from the top/bottom of the unit (near the

rear of the unit).

2. Using the screws provided with the rack mount kit, screw the mounting

bracket into the KN1000 – as shown in the diagram below:

Note: The illustrations show the mounting bracket attached to the bottom

of the unit; it can also be attached to the top.

1. Important safety information regarding the placement of this device is

provided on page 149. Please review it before proceeding.

2. Make sure that the power to any device that you connect to the

installation has been turned off. You must unplug the power cords of

any computers that have the Keyboard Power On function.

3. Any installation that does not follow the instructions in this guide may

be hazardous.

Phillips hex head

M3 x 8

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 193 194

Pas de commentaire

Altusen KN1000 Manuel d'utilisateur Page 27