Altusen KM0432 Manuel d'utilisateur télécharger pdf (Page 41)

Chapter 2. Installation

Network Installation

Before you can configure the KM0832 settings (discussed in Chapter 3), you

must first install the KM0832 on the Local Area Network (LAN).

To install the KM0832 on the LAN:

1. Locate the Configuration Port on the rear panel of the KM0832. (It has a

standard RJ-45 connector like those used for Ethernet access ports.)

2. Use Category 5e or Category 6 cable to connect the Configuration Port to

the LAN.

Topology Considerations

The use of RJ-45 CPU connectors, combined with Auto Signal Compensation

(ASC), allow signals to travel up to 300 meters (1000 feet) and still maintain

reliability and high video resolution. This allows the KM0832 installation to

take advantage of the internal Category 5e and Category 6 wiring built-in to

most modern commercial buildings.

Note: Although the KM0832 supports legacy Category 5 wiring, the

performance and video quality may degrade over longer distances. We

strongly recommend that you use Category 5 shielded twisted pair

(STP) cable.

Since the data signals are not transmitted in packets, the transmission cannot

go through network hubs or switches. Passive components such as patch

panels, keystone jacks, patch cables, etc. can be used to channel the traffic,

instead.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 137 138

Pas de commentaire

Altusen KM0432 Manuel d'utilisateur Page 41